Compaq 117755-003 - ProSignia - 740 White Paper page 21

467A/0197
W P
HITE APER
(cont.)
. .
. .
3. You can choose the following Windows NT 4.0 installation methods:
. .
. .
. .
Direct CD-ROM install
. .
. .
Boot-up floppies
. .
. .
NOTE: For this scenario, the Direct CD-ROM method was chosen.
. .
. .
. . 4. Insert the Windows NT 4.0 CD into the CD-ROM drive.
. .
. .
a) From the file manager, select the drive letter that represents the CD-ROM drive.
. .
. .
b) Change to the i386 directory.
. .
. .
c) Type in winnt32 /b (to create boot floppies, you would type winnt32 /ox in the same
. .
. .
i386 directory).
. .
. .
5. The "Windows NT 4.0 Installation/Upgrade" screen displays. Press Enter when you are
. .
. .
prompted; this starts the installation of Windows NT Server 4.0. Follow the instructions and
. .
remove the CD from the drive when you are prompted.
. .
. .
6. The system re-starts, the Microsoft install detects a CPQARRAY and Symbio Logic C810
. .
. .
PCI SCSI Host Adapter, (or another type of hard disk controller might be detected
. .
. . depending on your hardware configuration). You are then asked to enter additional driver
. .
information. Your available choices are:
. .
. .
Press the Enter key to continue, or
. .
. .
Press the letter S to specify additional drivers, or
. .
. .
Press F3 to exit.
. .
. .
Select or press Enter, if you choose to specify additional drivers you must have the latest
. .
. . Compaq Support Software.
. .
. .
7. Press the Enter key to continue. The licensing screen displays. After reading the licensing
. .
agreement, press F8 for "I agree" or ESC for "I do not agree".
. .
. .
. .
8. The next screen asks if you want to
. .
. . Press Enter to upgrade, or
. .
Press the letter N to install a new version, or
. .
. .
Press F3 to exit.
. .
. .
. .
Select or press Enter to upgrade.
. .
. .
9. You may then choose to scan the hard drive or skip detection;
. .
. .
Press Enter to scan the hard drive, or
. .
. .
Press ESC to skip detection.
. .
. .
Press Enter to scan your hard drive
. .
. .
10. After your disk scan completes, a rectangular bar displays in the lower half of the screen or
. .
. .
monitor, indicating files are being copied to your hard disk. At some point during the file
. .
copy process, the following message might display:
. .
. .
. .
Setup has determined the following file did not originate from Microsoft:
. .
oemnadnf.inf
. .
. .
This file may have been provided by your hardware manufacturer
. .
. .
. .
. .
. .
21