Table of Contents
Advertisement
2.
Intel
H77 Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1/2 [gray])
®
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial ATA 6.0
Gb/s signal cables.
P8H77-M PRO_DP
P8H77-M PRO_DP Intel
• These connectors are set to [IDE] by default. If you intend to create a Serial ATA RAID
set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].
See section 4.4.3 SATA Configuration for details.
• Before creating a RAID set, refer to the RAID Supplementary Guide included in the
folder named Manual in the support DVD.
• You must install Windows
hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if
you are using Windows
• When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to
[AHCI]. See section 4.4.3 SATA Configuration for details.
3.
Serial port connector (10-1 pin COM1)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
P8H77-M PRO_DP
P8H77-M PRO_DP Serial port (COM1) connector
The COM module is purchased separately.
ASUS V-P8H77E
SATA 6.0Gb/s connectors
®
XP Service Pack 3 or later version before using Serial ATA
®
XP SP3 or later version.
®
COM1
PIN 1
3-5
Advertisement
Table of Contents
