Table of Contents
Advertisement
2.6 Install a CD/DVD-ROM drive
In the future, you may want to upgrade your CD/DVD-ROM drive for higher
speed. Follow these steps to install a CD/DVD-ROM drive.
1.
After dislodging the disk drive assembly and disconnecting all cable
connections, place disk drive assembly on a stable surface.
2.
If you are replacing an installed CD/DVD-ROM drive, first remove the
four screws (two on each side) to dislodge currently installed drive.
3.
Slide the new CD/DVD-ROM drive in the vacated CD/DVD-ROM
drive slot. Properly match the screw holes on each side of the drive. If
the screw holes doesn't match, pull the drive out and reverse the
drive entry.
4.
After properly matching the screw holes, tighten the four screws (two
on each side). Make sure the drive is stable in place.
2-10
Chapter 2: System Assemby
Hide quick links:
Advertisement
Table of Contents
