Onkyo BD-SP809 Instruction Manual page 20

Controlling AV Components that are Out-of-Range
You can use the following multi-room kits to control this unit when it's out of range of the remote controller:
• Multiroom kits such as those made by Niles and Xantech.
Controlling Other Out-of-Range AV Components
If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to
retransmit the remote controller signals received at this unit's IR IN jack, as shown below.
IR IN
IR OUT
Connect the IR emitter to this unit's IR OUT jack, and place the IR emitter in front of the other AV component's
remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR
emitter.
from connecting block
Only remote controller signals received by this unit's IR IN jack are fed through to the IR OUT jack. Signals picked up by
this unit's remote control sensor are not output.
20
Connecting block
This unit
IR emitter
Other
component
Miniplug cable (not supplied)
Remote controller
Other component
Miniplug
IR emitter
Signal flow
Remote control sensor
IR emitter
Signal flow
EN