Table of Contents
Advertisement
Noise reduction (DVD-video only)
Reduces the noise of the playback picture.
"Off" : Shows the original picture as recorded.
"1"
: Executes 3D noise reduction which detects and
deletes the noise by comparing each picture
frames.
"2"
: Executes MPEG noise reduction which reduces the
block noise and mosquito noise on the subtitle on
movie.
"3"
: Executes both MPEG noise reduction and 3D noise
reduction.
3
Press [RETURN] to exit.
Note
• The setting will remain the same even if the unit is
turned to the standby mode.
• "Black Level" is not effective under the following
conditions.
- When the picture is output from HDMI OUT jack.
- When the picture is output from COMPONENT
VIDEO OUT jacks with "Component Output" set to
"480p / 720p / 1080i".
• You cannot adjust the setting during rapid playback.
Virtual Surround
You can enjoy stereophonic virtual space through your
existing 2 channel stereo system.
1
During playback, press [MODE].
2
Use [K / L] to select your desired setting.
Off
"Off" : No surround effect
"1"
: Natural surround effect
"2"
: Stronger surround effect
3
Press [RETURN] to exit.
Note
• Set the virtual surround setting to "Off" or lower the
volume if the sound is distorted.
• Virtual surround does not function during rapid
playback.
• For the virtual surround, audio signal will always be
2-channel LPCM.
26
PLAYBACK
PIP (BONUSVIEW) Setting
Some BD-video have the PIP function which enables you
to display the secondary video in the primary video. You
can call up the secondary video by pressing [MODE]
whenever the scene contains the secondary video.
primary
video
secondary
video
1
During playback, press [MODE] repeatedly
until the PIP function appears.
2
Use [K / L] to select the secondary video you
want.
• The secondary video will be displayed and the
secondary audio will be output.
• Use [s / B] to switch between current setting and
"Off".
3
Press [RETURN] or [MODE] to remove the PIP
information.
Note
• The secondary audio will not be output when the
secondary audio is set to "Off" or when "BD Audio
Mode" is set to "HD Audio Output". Refer to
"Switching Audio Soundtrack" on page 29 and
"Setting the BD Audio Mode" on page 30.
Camera Angle
Some BD-video and DVD-video contain scenes which have
been shot simultaneously from various angles. You can
change the camera angle when
screen.
1
During playback, press [ANGLE].
• The selected angle will be displayed on the display
bar at the top of the TV screen.
2
Use [K / L] to select your desired angle.
1 / 3
Note
• If "Angle Icon" setting is "Off" in "Others" menu,
will not appear. Refer to page 42.
appears on the TV
EN
Advertisement
Table of Contents
