Removing The Collected Water - Heat Controller BHD-301 Owner's Manual

Heat Controller, Inc.
OPERATING THE UNIT

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the unit will automatically stop
running, the unit will beep 8 times and and the Full
indicator light will flash, the digital display shows P2 .
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the tank on the floor
because the bottom of the bucket is uneven. Otherwise
the bucket will fall and cause the water to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The unit will re-start when the bucket is restored
The machine will re-start when the bucket is restored
in its correct position.
NOTES:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
2. Continuous draining
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
0.5 in. ( 12mm) (not included).
(O12mm) (not included).
Remove the water bucket from the front of the
unit, you will find a section of hose located
above the bucket.
Remove the rubber plug from the back of the
unit and store it in a safe location (see Fig.8).
Insert the water hose through the hole in the
back of the unit and securely press it into the
connector on the front of the unit (Fig.9). Then
lead the water hose to the floor drain or a suitable
location.
drainage facility.
Replace the bucket in the unit. The bucket must
be in place and securely seated.
NOTE: When the continuous drain feature is not being
NOTE: When the continuous drain feature is not being used,
used, remove the drain hose from the connector and
remove the drain hose from the connector and attach the
attach the back drain hole with the rubber plug shown
rubber plug back over the drain hole as shown in Fig. 1.
in Fig.1.
BHD-G Portable Dehumidifier
onto
8
8
www.sylvane.com 1-800-934-9194
Owner's Manual
1. Pull out the bucket a little.
Fig.5
2. Hold both sides of the bucket
2. Hold both sides of the bucket
securely and pull it out from
with even strength, and pull it
the unit.
out from the unit.
Fig.6
3. Pour the water out.
Fig.7
Remove the
rubber plug
Push the hose
into the drain
hole
Drain hose
Connector
Fig.8
Fig.9