Table of Contents
Advertisement
73090 Rev 1
28/4/04
Assembly
To use as an upright
1 Fit the floor nozzle by pressing in the locking
pin and insert the nozzle into the hole at the
base of the body
2 Locate the telescopic handle into the body
by pushing in the locking pin and lowering
the handle in until the locking pin locates in
E
the locking hole
⁄
release button
3 Adjust the telescopic handle by sliding the
‹
button
down and pulling out or pushing
F
in the lower half
To use as a handheld
1 Remove the telescopic handle.
2 Remove the floor nozzle by pressing in the
Ï
release button
nozzle away from the body
3 Slide the hose end
Á
H
location
.
5:42 PM
Page 4
A
D
. Push down fully.
. To remove, press in the
and lift the handle out.
.
B
and pulling the floor
G
.
Ë
from the hose end
D
E
4 Fit the extension tube
Ë.
Ò
5 Fit the crevice tool
6 If required fit the brush
crevice tool.
Attachments
Uses for the brush attachment include
stairs, upholstery, mattresses, curtains and hard
surfaces like door mouldings and skirting
boards. The crevice tool is particularly useful for
cobwebs and in narrow gaps in the car around
the handbrake and seat.
‹
4
to the hose end
to the extension tube.
Ú
to the end of the
F
G
H
Advertisement
Table of Contents
