Before First Use; Operating The Appliance; Additional Features - Morphy Richards 2 SLICE ACCENTS TOASTERS WITH PAUSE AND CHECK Instructions Manual

44323 rev2 16/4/08

BEFORE FIRST USE

• Before using the toaster for the
first time, operate the toaster
without bread.
Note: The bread carriage lever(s)
¤ will not stay down unless the
toaster is plugged in and the wall
switch is on. Ventilate the room
during this process.
• As with all new electric heating
elements, your toaster emits a
'new' smell when it is first
switched on. This is quite normal
and not a cause for concern.
OPERATING THE
APPLIANCE
On the four slice models, the
toaster has two sides with
controls repeated for each half.
Each half can be used together
or independently.
1 Select the desired level of
browning on the browning
control dial fl.
2
After selecting the desired level,
place your bread in the slots ⁄
and depress the bread carriage
lever downwards until it locks.
3 After the set time has been
reached, the bread will pop up
automatically - ready for removal
from the slots. The bread carriage
lever will have returned to it's
upper position and the heating
element will have switched off.
WARNING: Do not wrap the
cable around the main body of
the appliance during or after
use.
ADDITIONAL
FEATURES
Using the re-heat
button
If your toast has popped up and
gone cold, the toaster offers a re-
heat facility. To use, depress the
relevant bread carriage lever and
press the re-heat button ›
immediately. The button will
illuminate and the toaster will
operate for a short period
re-heating the bread.
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 5 5 7 7
4 4
11:01 Page 6
Using the
frozen button
To toast frozen bread, do not
adjust the browning control from
your normal setting. Place the
bread in the bread slots as
normal, and press the frozen
button ‹.
Using the pause
and check /
cancel button
If you wish to check the process
of the toasting cycle, press the
Pause and check / cancel button
fi. On pressing the button, the
bread carriage will pop up
automatically for you to check.
This action will pause the heating
elements, during this period, the
function button lights will flash. If
you have achieved the desired
level of browning, remove the
toast from the toaster. If longer
toasting is required, depress the
bread carriage lever within 5
seconds to resume the toasting
cycle at the same stage it was at
when it was paused.
Hints and tips
• In order to achieve uniform
browning, we recommend you wait
a minimum of 30 seconds
between each toasting, so that the
control can be automatically reset.
• If toasting one slice only, you may
need to adjust the browning
control to a slightly lower setting.
• Please note: you will also notice a
slight variation in toast colour on
one side of a single slice.
• Stale bread toasts more rapidly
than fresh bread. Therefore, the
browning control should be set at
a lower setting than usual.
• All sorts of bread can be used, as
well as teacakes, small rolls etc.
However, slices should not be so
thick as to cause burning or
jamming within the bread slots.
• If the bread in your toaster
becomes jammed, disconnect
your toaster at the socket, allow
it to cool, then remove the bread.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 2 2 3 3 I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9