BMW X3 2004 Owner's Manual page 74

Loading cargo with the rear seat
back folded down
Holders for the cassette are fitted to the
backs of the rear seat backs, refer to
arrow 1.
Guide in the cassette from the right side
until it locks in place, refer to arrow 2. Here,
the cargo area cover must always point in
the direction of travel and the loop of the
partition net must point upward.
You can pull out the partition net and insert
it in the holders in the roof area above.
Partition net*
Pull the partition net by the loop from the
cassette; hold the bar on both sides and
insert in the holder.
Do not allow the partition net to snap
back into place, as otherwise there is
a danger of injury and the partition net
could be damaged.<
72
Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG
Behind the side trim panel
Press the button to open.
Floor cover
Opening
For access to the compact wheel etc.
To open, raise the cover by the handle,
refer to arrow.
If required, you can remove or raise the
floor cover.
Raising
Swing up the floor cover and hook it onto
the handle of the cargo area cover with its
catch.