BMW X3 2004 Owner's Manual page 40

Hide thumbs Also See for X3 2004:
Table of Contents

Advertisement

sion control system components, espe-
cially the catalytic converter.
Service Engine Soon indicator lamp
for Canadian models.
Malfunction in the engine electron-
ics.
You can continue to drive with
reduced engine output or engine speed.
Please have it checked by your BMW
Sports Activity Vehicle Center.
Starting the engine
When starting the engine, do not press the
accelerator pedal.
Vehicles with manual transmission:
Step on the clutch when starting the
vehicle. A lockout prevents the engine from
starting if the clutch is not
Do not actuate the starter for too
short a time. Do not turn it for more
than approx. 20 seconds. Release the igni-
tion key immediately as soon as the engine
starts.<
If the engine fails to start on the first
attempt, for instance, if it is very hot or cold:
Press the accelerator pedal halfway
>
down while engaging the starter.
During a cold start at very low tempera-
tures, as of approx. +5 7/–156, at high
altitudes over 3,300 ft/1,000 m:
For the first attempt, run the start for
>
longer, approx. 10 seconds
Press the accelerator pedal halfway
>
down while engaging the starter.
Avoid frequent starting is quick suc-
cession or repeated start attempts in
which the engine does not start. Otherwise,
the fuel is not burned or inadequately
burned and there is a danger of overheat-
ing and damaging the catalytic
Manual transmission
1.
Engage the handbrake
2.
Gearshift lever in idle position
3.
Press the clutch pedal
4.
Start the engine.
38
depressed.<
converter.<
Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG
Before leaving the vehicle with the
engine running, place the gearshift
lever in idle position and apply the hand-
brake.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety
Automatic transmission
1.
Press the brake pedal
2.
Place the selector lever in position P
or N
3.
Start the engine.
To prevent the vehicle from rolling,
always select position P and engage
the handbrake before leaving the vehicle
with the engine running.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety
Switching off the engine
Do not remove the ignition key when
the vehicle is moving, as otherwise
the steering could lock.
When leaving the vehicle, always remove
the ignition key and lock the steering.
When parking on downward inclines, apply
the
handbrake.<
Manual transmission
Turn the ignition key to position 1 or 0.
Automatic transmission
Engage selector-lever position P, turn igni-
tion key to position 1 or 0.
Handbrake
The handbrake is primarily intended to pre-
vent the vehicle from rolling while parked; it
brakes the rear wheels.
Indicator lamp
The indicator lamp lights up from
ignition switch position 2 with the
handbrake set – an acoustic signal
also sounds when starting off.
hazard.<
hazard.<

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

X3 2.5iX3 3.0i

Table of Contents