Dell POWEREDGE 1900 Hardware Owner's Manual page 25

Table 1-5. System Messages (continued)
Message
Diskette drive n seek
failure
Diskette read failure
Diskette subsystem reset
failed
Drive not ready
Error: Incorrect memory
configuration. DIMMs must
be installed in pairs of
matched memory size,
speed, and technology.
Error: Memory failure
detected. Memory size
reduced. Replace the
faulty DIMM as soon as
possible.
!!*** Error: Remote Access
Controller initialization
failure*** RAC virtual USB
devices may not be
available...
FBD training error: The
following branch has been
disabled: Branch x
Causes
Incorrect configuration settings in the
System Setup program.
Faulty or improperly installed diskette
drive.
Loose diskette drive interface cable, or
loose power cable.
Faulty or improperly inserted diskette. Replace the diskette. If the problem
Faulty or improperly installed
diskette.
Diskette missing from or improperly
inserted in diskette drive.
Mismatched or unmatched DIMMs
installed; faulty or improperly seated
memory module(s).
Faulty or improperly seated memory
module(s).
Remote Access Controller
initialization failure
The specified branch (channel pair)
contains DIMMs that are
incompatible with each other.
Corrective Actions
Run the System Setup program to
correct the settings. See "Using the
System Setup Program" on page 33.
Replace the diskette. If the problem
persists, see "Troubleshooting a Diskette
Drive" on page 112.
Reseat diskette drive interface cable, or
power cable. See "Troubleshooting a
Diskette Drive" on page 112.
persists, see "Troubleshooting a Diskette
Drive" on page 112.
Replace the diskette. If the problem
persists, see "Troubleshooting a Diskette
Drive" on page 112.
Replace the diskette. If the problem
persists, see "Troubleshooting a Diskette
Drive" on page 112.
Ensure that all pairs of memory modules
are of the same type and size and that
they are properly installed. See
"Memory" on page 80. If the problem
persists, see "Troubleshooting System
Memory" on page 110.
See "Troubleshooting System Memory"
on page 110.
Ensure that the Remote Access
Controller is properly installed. See
"Installing a RAC Card" on page 85.
Ensure that only Dell-qualified memory
is used. Dell recommends purchasing
memory upgrade kits directly from
www.dell.com or your Dell sales agent to
ensure compatibility.
About Your System
25