BMW K 1200 LT Operating Instructions Manual page 15

» The reset mode is active.
» rE flashes for 5 seconds in
display 2.
» The system has now been
reset to its default settings.
The default volume for
output via the helmet
speakers might not match
your own personal
preferences.
Remove the helmets before
restoring the default
settings.c
The default settings are
not restored if you re-
lease the knob before the LED
stops flashing.c
Activation thresholds of
the microphones
Ambient noise increases as
the motorcycle's speed
increases (wind noise is a case
in point) and this higher noise
level could be sufficient to acti-
vate the microphones. In order
to avoid inadvertent activation
of this nature, the system has
activation thresholds to enable
automatic adjustment to the
noise level. Consequently,
when the motorcycle is travel-
ling at speed you and your
passenger must speak more
loudly into the microphones in
order to activate them.
If automatic activation of the
microphones is not to your satis-
faction, you can manually adjust
the activation threshold sepa-
rately for each helmet (
The lower you set the
activation threshold, the
greater is the possibility of am-
bient noise activating the
microphone. Bear in mind that
inadvertent activation could
cause the audio source to fade
out, even though neither you
nor your passenger had spo-
ken into the microphone.c
Speed-dependent
volume increase
The communication system
can automatically adapt the
playback volume to the speed
of the motorcycle. Note that in
order for it to do so, however,
the equivalent function must
be switched off at the radio
and you must have selected
one of five possible settings
( 13).
b
13).
b
2
11