Returning A Hard Drive To Dell - Dell Inspiron 9300 Owner's Manual

To replace the hard drive:
1 Follow the procedures in "Before You Begin" on page 81.
2 Turn the computer over, and remove the hard drive screws.
NOTICE:
"Protecting Against Electrostatic Discharge" in the Product Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE:
damage the connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 If the new hard drive is not already pre-imaged, install the operating system and drivers for
your computer.

Returning a Hard Drive to Dell

Return your old hard drive to Dell in its original or comparable foam packaging. Otherwise, the
hard drive may be damaged in transit.
84
Adding and Replacing Parts
screws (2)
When the hard drive is not in the computer, store it in protective antistatic packaging. See
Use firm and even pressure to slide the drive into place. If you use excessive force, you may
hard drive