Copying A Video Tape - Magnavox MWD2205 Owner's Manual

Copying a Video Tape

Warning: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.
(Back of another source)
1
DVD/VCR VCR
or
COMPONENT AUDIO OUT AUDIO IN
VIDEO OUT AUDIO OUT
ANT-IN
Y L L
Connect
C R R
B
VIDEO OUT VIDEO OUT VIDEO IN ANT-OUT
C
R
Audio/Video cables
(not supplied)
1) Insert a pre-recorded tape into the playing VCR.
2) Insert a tape with its record tab into the recording unit.
3) Hit [SPEED] on the remote control of the recording unit to select the desired recording speed (SP/SLP).
4) Select the "L1"or "L2" position on the recording unit.
• To use the input jacks on the back of this unit, select "L1" position by pressing [0], [0], [1] on the remote control or
[CHANNEL K K /L L ].
• To use the input jacks on the front of this unit, select "L2" position by pressing [0], [0], [2] on the remote control or
[CHANNEL K K /L L ].
5) Hit [RECORD] on the recording unit.
6) Begin playback of the tape in another source.
7) To stop recording, hit [STOP/EJECT C C A A ] on the recording unit, then stop playback of the tape in another source.
Hint
Hint
• For best results during dubbing, use the front panel controls whenever possible. The remote control might affect another source's operation.
• Always use video-quality shielded cables with RCA-type connectors. Standard audio cables are not recommended.
• You can use a video disc player, satellite receiver or other audio/video component with A/V outputs.
• "L1" or "L2" is found before the lowest memorized channel. (Example: CH02)
• "L2" input jacks are on the front of this unit.
(Back of Recording DVD/VCR*)
DVD DVD/VCR VCR
DIGITAL AUDIO S-VIDEO COMPONENT AUDIO OUT
Connect
VIDEO OUT
AUDIO OUT OUT OUT ANT-IN
Y L
AUDIO IN
L
C R R
B
COAXIAL
VIDEO OUT VIDEO IN
R ANT-OUT
C R
RF cable
(supplied)
*Front input jacks are also available
(Back of TV)
2
– 14 – EN