C Preparation For Use; Antenna/Cable Connections - Sylvania 6319CCB Owner's Manual

ANTENNA/CABLE
CONNECTIONS
VHF/UHF COMBINED ANTENNA
The VHF/UHF Rod Antenna (supplied with 13 inch
model only) is detachable. Insert the stem of the
antenna into the hole on the upper-back portion of
the TV/VCR.Connect the VHF/UHF Rod Antenna or
VHF/UHF Combination Antenna to the ANT. termi-
nal of the TV/VCR as shown in the diagram
below.For the best reception, fully extend the
VHF/UHF Rod Antenna and make the necessary
adjustments. (Avoid touching the top section when
adjusting.)
NOTE:
Before plugging the Rod antenna into antenna termi-
nal, check that the pin is not bent. If it is bent,
straighten the pin as illustrated, then plug the pin into
antenna terminal.
Bent pin
Cable Plug
(Needs to be straightened)
Rod Antenna
(Supplied with
13" model)
ANT.
NOTE:
The connection of an indoor antenna may not always
give acceptable TV reception.
Antenna/Cable Connections Continued on the Next Page.
PREPARATION FOR USE
(Straight pin)
VHF/UHF Antenna
(Not supplied)
ANT.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor
antenna.
ANT.
ANT.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection you can:
1) Use the TV/VCR remote to select channels.
2) Program one or more unscrambled channels for
Automatic Timer Recording.
NOTE: This unit will ONLY record and view the
same channel.
From Cable System
75-ohm Coaxial
Cable (Not
supplied)
ANT.
- 10 -
VHF Antenna (Not supplied)
UHF Antenna
(Not supplied)
VHF/UHF
Combiner
(Not
supplied)
Flat twin-lead cable
ANT.
EN
9I03