Table of Contents
Advertisement
Remove the system unit cover (see "Removing the
2.
Desktop Cover" or "Removing the Minitower Cover"
in Chapter 3).
3.
Locate the Password Clear jumper J1K2 (A) on the
system board (see the figure "Locating system
configuration jumpers" earlier in the chapter).
You may have to remove any installed expansion
boards to access the jumpers (see "Removing
Expansion Boards" in Chapter 3).
Move the jumper block to the Password Clear position.
4.
Password Clear
Password Enabled (Default)
Jumper 1-2 (A)
Password Clear
Jumper 2-3 (A)
Replace the system unit cover (see "Replacing the
5.
Desktop Cover" or "Replacing the Minitower Cover"
in Chapter 3).
Connect system power cables and monitor.
6.
Power on the system. The system lets you boot your
7.
computer.
Power off, unplug the system and monitor, and remove
8.
the cover.
J1K2
4
6
1
3
1
A
4
6
1
3
1
A
Clear Password Jumper
Setting System Board Jumpers 5-11
4
B
4
B
Advertisement
Table of Contents
