Installing Cheyenne Backup; Identifying The Pentium Iii Processor - NEC POWERMATE 8100 - RELEASE NOTES Release Note

Hide thumbs Also See for POWERMATE 8100 - RELEASE NOTES:
Table of Contents

Advertisement

2. Double click the
3. Click the
are loaded:
NetBEUI Protocol
NWLink IPXSPX-Compatible Transport
NWLink NetBIOS
4. Highlight
warning window appears asking for confirmation to continue.
5. Click
Yes
NetBIOS lines disappear from the Protocols display.
6. Repeat steps 4 and 5 to remove the
7. Click
Add
8. Highlight
appears. If there is a DHCP server on the network, click
click
No
9. Change the path in the window to
window appears. If Yes was clicked in step 8, skip to step 16. If No was
clicked in step 8, the Windows Setup window appears.
10. Click
Close
11. Fill in the
"Specify an IP address" area.
12. Click the
13. Click the
14. Click the
15. Click the
16. Click
OK

Installing Cheyenne Backup

After installing the Cheyenne
system, an "Unable to connect to Group" error message is displayed. This
message indicates that a backup tape unit is not installed. Installing a tape unit
or reconfiguring the Cheyenne Backup utility removes this message.

Identifying the Pentium III Processor

NEC computer systems with the Intel
with the most advanced Intel Pentium processor available.
icon in the Control Panel window.
Network
tab. In the Protocols display, the following protocols
Protocols
NWLink IPXSPX-Compatible Transport
. The NWLink IPXSPX-Compatible Transport and NWLink
. The Select Network Protocol window appears.
TCP/IP Protocol
and click
.
. The Microsoft TCP/IP Properties Box appears.
, the
IP Address
Subnet Mask
DNS
tab and enter the host and domain name in the DNS display.
Identification
tab and change the Computer Name if appropriate.
tab and enter the WINS address if appropriate.
WINS
tab and enable IP forwarding if appropriate.
Routing
. When prompted to restart the system, click
®
Backup utility on the system and rebooting the
NEC PowerMate 8100 Series Release Notes 7
and click
Protocol.
NetBEUI
OK
. The TCP/IP Setup window
. Click
C:\I386
Continue
, and the
Default Gateway
Yes
®
®
Pentium
III processor come equipped
Remove
. A
Yes
; otherwise
. The Network
in the
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powermate 8100 series

Table of Contents