NEC VERSA P7500 Series User Manual page 90

Table of Contents

Recovery Information for Windows Vista

Recovery Information for Wi

NEC Recovery Program (from backup partition)

Your computer is supplied with a backup partition on the hard disk drive which contains all data you may

need in order to restore your configuration as it was when leaving the factory. This partition occupies about

10 GB of your hard disk drive.

This backup partition is hidden.

The NEC Recovery Program can restore your computer to the same state as when you purchased it, while

giving you an option to retain all settings and personal data for later retrieval.

Due to the wide range of reasons for which the NEC Recovery Program may be used, no

guarantee can be given that all data will be retained.

The procedure described below is only applicable if your backup data is stored on your computer's hard disk.

If you wish to restore your computer using Recovery DVD, please see note below.

You are strongly recommended to create a set of Recovery DVD for future use.

Be ready with 2 blank DVD-R. Please use the MDVDCreator tool. Click on the icon at Start button

- All Program – MDVDCreator

through the process.

Before you run MDVDCreator program, you need to disable UAC (User Account Control). To do this,

go to Start button

Turn User Account Control on or off. Then uncheck the "Use User Account Control (UAC) to help

protect your computer". Click OK button.

to launch MDVDCreator program. It will guide you

- Control Panel - User Account and Family Safety - User Accounts -

ndows Vista ® ® ® ® only

ndows Vista

only

- 90 -

Table of Contents