Table of Contents
Advertisement
Document Revision 1
___________________________________________________________________________________
5.4
___________________________________________________________________________________
2 - 8
Installing the Repeater
Be sure the wall material can hold the weight of the repeater. Never
install a repeater in damaged or decaying wall material.
1.
Hold the repeater in its final location, and mark the center of the top
edge.
2.
From the edge mark, measure down approximately 1-1/2 inches, and
mark the screw location.
3.
At the screw location, use a 3/16ths drill bit to make a pilot hole
approximately one inch deep.
4.
Place the wall anchor into the pilot hole and tap it gently with a hammer
until the anchor is flush with the wall.
5.
Insert the mounting screw into the anchor, leaving approximately 1/4
inch space between the screw head and the wall.
6.
Put the wall mount slot on the back of the repeater over the screw head
and slide the repeater down into place.
Figure 2-5 Wall Mounting Repeater
term
D
Cordless DECT
Getting to Know Your Repeater
Advertisement
Table of Contents
