Connecting To A Power Source; Figure 3-6 Power Socket - SMC Networks 8708L2 Installation Manual

Connecting to a Power Source

To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket located at the
back of the switch.
2. Plug the other end of the cable into a grounded, 3-pin, AC power
source.
Note: For International use, you may need to change the AC line cord.
3. Check the front-panel LEDs as the device is powered on to be sure
the PWR LED is lit. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Supply, connect it to the
device and to an AC power source now, following the instructions
included with the package.
100-240V~
50-60Hz 2A

Figure 3-6 Power Socket

You must use a line cord set that has been approved for the
socket type in your country.
C
ONNECTING TO A
P S
OWER OURCE
3-9