SMC Networks 7904BRB3 User Manual page 26

Label
Use the following IP
address
WAN IP Address
WAN Subnet Mask
Default Gateway
Obtain DNS server
addresses automatically
Use the following DNS
server addresses
Primary DNS server
Secondary DNS server
Enable NAT
< Back
Next >
If you finish the settings of this page, click Next, the screen of Fig 3.3.1-6 appears. For the settings of this
screen, see above paragraphs.
If you select 1483 Routed in Fig 3.3.1-2, the screen of Fig 3.3.1-9 appears as shown next.
The following table describes the fields of this screen.
Label
None
Obtain an IP address
automatically
SMC7904BRB3 User Manual
If you want to input the WAN ip address by yourself. Check this entry and
then input related data in the field.
Input the IP address of the WAN interface provided by your ISP
Input the subnet mask concerned to the IP address of the WAN interface
provided by your ISP.
You can input the IP address of the default gateway by yourself, click this
entry and then input related data in the fields.
To obtain the IP address of the DNS server assigned by the uplink
equipment such as BAS.
If you want to input the IP address of the DNS server by yourself, click this
entry and then input related data in the fields.
Input the IP address of the primary DNS server here.
Input the IP address of the secondary DNS server provided by your ISP
here.
Select it to enable the NAT functions of the MODEM. If you are not to
enable NAT and intend the user of the MODEM to access the Internet
normally, you must add a route on the uplink equipment; otherwise the
access to the Internet fails. Normally, it is required to enable NAT.
Click < Back to return to the previous screen
Click Next > to go to the next screen
Fig 3.3.1 -9
-
The dynamic IP is not fixed; your ISP assigns you the different one each
time.
19
Description
Description