Jabra CLIPPER User Manual page 11

I cannot hear the phone call in the headset
- Increase the volume on the Jabra CLIPPEr .
- Make sure your phone is connected to the headset by i .e .
tapping the Multi-Function button, or viewing the LED
indicator .
I have pairing problems
- You may have deleted the pairing connection in your mobile
phone – follow the pairing instructions in 'Pair Your Headset to
a Phone or other Device ' .
I cannot use Reject call or Redial
- These features are dependent on your phone supporting them;
please consult your phone's manual for details .
I cannot hear music in the headset
- Ensure that the headset is connected to your Bluetooth®
enabled device .
- You may have been out-of-range (10 meters) to your Bluetooth®
enabled device or the headset might have experienced an ESD
(Electrostatic discharge) incidence . Press the Multi-Function
button to re-establish the Bluetooth® audio link - Increase the
volume on your device .
- Make sure that the Jabra CLIPPEr is charged .
The music I hear sounds very poor
Make sure the other device supports Bluetooth® 1 .1 or higher
including the advanced audio Distribution Profile (a2DP) for
music streaming .
If the above procedure did not help then it is possible that your
phone is using the stereo audio connection in a different way . You
can enable this mode on Jabra CLIPPEr by performing pairing in
the following way:
- remove the Bluetooth® connection to Jabra CLIPPEr on your
phone .
- Make sure the headset is on .
- Press and hold the Multi-Function button for more than 5
seconds until the LED display are solid blue .
- Go through the regular steps in pairing the headset to a
Bluetooth® device .
Jabra CLIPPEr
10