Adjust Gears; Remove And Fit Rear Wheel; Wear Parts - SRAM SPARC 16V Manual

M A I N T E N A N C E A N D C A R E
R E A R W H E E L / W E A R P A R T S
A D J U S T I N G G E A R S H I F T
Before adjusting the gearshift
5
you must set the twist-grip
shift from 4th gear back to 3rd
gear.
» Align the arrows in the inspection
window (1) of the Clickbox by
turning the adjustment screw (2)
on the gearshift cable.
R E M O V E R E A R W H E E L
Pull the plug of the control unit
6
off the hub. Push the button on
the plug of the battery cable to re-
move the plug from the Sparc drive.
» Release the knurled screw on the
Clickbox and remove the Clickbox.
» Pull off the red positioning bush
and remove the shift rod/-pipe
from the axle.
» Release the two axle nuts to re-
move the rear wheel.
» The rear wheel is re-fitted in
reverse order.
The cables must not be
squeezed or pinched.
Danger of short-circuit!
10
5
6
W E A R P A R T S
Bicycles chains, sprockets, shifting
cables, handlebar grips and batteries
are wear parts.
Take care of regular control and
timely replacement.
Sparc · July 2004
1
2