Install Rotor; Mount Front Caliper - SRAM Avid BB5 Installation And Setup Manual

BB7 and BB5 Installation & Set-Up Guide
1

INSTALL ROTOR

Mount the rotor to the hub using the supplied T-25 TORX
torque. Avid logo MUST face out. Install the wheel into the fork or frame.
WARNING:
IF YOU ARE USING A HUB WITH A REMOVABLE SHIM
. C
BOLTS ONTACT THE HUB MANUFACTURER FOR THE RECOMMENDED BOLTS
2

MOUNT FRONT CALIPER

Mount the front caliper to the fork.
TORQUE TO:
9-10 Nm (80-90 in-lb)
I.S. MOUNT
Loosen the CPS bolts, then bolt the caliper to the mounting
tabs. Tighten the mounting bolts to the specified torque.
Check that the caliper moves freely on the CPS hardware.
SRAM Corporation
bolts and tighten to the specified
®
,
YOU MAY NEED LONGER ROTOR MOUNTING
.
Remove...
OR
Loosen before
mounting
POST MOUNT
Remove the mounting bracket but leave the CPS bolts and
washer stacks intact. Bolt the caliper directly to the fork. Snug
the bolts, then back them out 1/8th to 1/4th turn. Check that
the caliper moves freely on the CPS hardware.
July 2005
TORQUE TO:
6.2 Nm (55 in-lb)
...then mount direct
Snug, then back off
1/8th to 1/4th turn
English
5