Aiwa NSX-MT725 Operating Instructions Manual page 22

This section explains how to record from the tuner, CD player, or
external equipment.
I
;
1.
1
Jd
/0 REC/
REC MUTE
bl+ F
Preparation
Use Type I (normal) and Type II (high/CrOz) tapes for recording.
Set the tape to the point where recording will start.
1
2
3
4
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
A PUSH
EJECT
Press REV MODE to select the reverse mode.
To record on one side only, select 1.
To record on both sides, select Z) or C=).
Press function (TUNER/BAND, VIDEO/AUX, CD or
MD) and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press VIDEO/AUX or
MD.
Press REC/REC MUTE to start recording.
When recording from a connected source, start playback of
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press H.
To pause recording, press 11. (Applicable when the source is
TUNER, VI DEO/AUX or MD) To resume recording, press it again.
To
start recording with the remote control
First press
\O REC/REC MUTE, and then press /+ within
2 seconds.
Sound adjustment during recording
The VOLUME control has no effect on recording. It only sets the
level feeding the speakers and headphones. Remember, however,
recording takes on the BEAT, AUTO SPICE/FILL IN, SPICE A/B
functions, as well as on the BBE function.
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER/
BAND, VIDEO/AUX or MD.)
1 Press REC/REC MUTE during recording or while in
recording pause mode.
~ on the display flashes for 4 seconds and 4-second blank
space is made. Then, the deck enters the recording pause
mode.
2 Press 11 to resume recording.
To insert a blank space of less than 4 seconds, press
REC/REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is added.
m
"Can't
REC" is
displayed
if you attempt to record on a tape with
the plastic tabs broken off.
To erase a recording
Make sure the microphone is not connected to this unit. Set the
microphone volume and the echo level to OFF (see page 28).
Also, check to make sure that BEAT and AUTO SPICE are
switched off (page 11).
1
2
3
4
Insert the'"ta~e to 'be erased into deck 2 and press TAPEI
DECK 1/2 to display "TP 2".
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing REV MODE.
Press REC/REC MUTE to start the erasure.
22
ENGLISH