NAD C356BEE Owner's Manual page 13

USING THE SR 8 REMOTE CONTROL LIBRARY
The SR 8 can store a different library of default NAD codes for each of its
DEVICE SELECTOR "pages. " If the original default library does not control
your NAD CD player, DVD player, or other component, follow the procedure
below to change the library code. Refer as well to the table below for a list
applicable NAD Library Codes with their corresponding NAD models.
LOAD ANOTHER LIBRARY CODE
Example: Load NAD DVD Player T 517 library code to SR 8's "CD" device.
1 Press and hold [CD] in the DEVICE SELECTOR section of SR 8.
2 While holding down the device button (CD), press "2" and "2" using
SR 8's numeric buttons. "22" is the corresponding library code for T 517.
3 Press [ENTER] while still holding down the device button (CD). The
CD device selector will flash once to indicate that the library input is
successful. Both the device selector button (CD) and [ENTER] can now
be released.
RESET THE SR 8 TO ITS DEFAULT SETTINGS
The SR 8 can be restored to its factory settings, including default libraries, by
the following procedures
1 Press and hold [ON] and [DELETE/CLEAR] buttons for about 10 seconds
until the AMP device button lights up.
2 Within two seconds of the AMP device button lighting up, release both
buttons. If the reset mode is successful, the [CD] device button will flash
twice.
TABLE OF LIBRARY CODES APPLICABLE TO SR 8 REMOTE CONTROL
LIBRARY CODE NAD PRODUCT DESCRIPTION
10 Default library for "AMP" page
11 Zone 2
20 Default library for "CD" page; C 515BEE, C 545BEE, C 565BEE
21 T 535, T 585, M55, DVD section of L 54, VISO TWO, VISO FIVE
22 T 513, T 514, T 515, T 517
23 T 587, T 557, T 577, M56
30 IPD 1
31 IPD 2
Default library for "TUN" page; Tuner section of C 725BEE, T 175,
40
T 737, T 747, T 755, T 765, T 775, T 785
41 C 422, C 425
42 C 445
NOTE
The SR 8 may not necessarily contain all the control buttons applicable
for the above-mentioned NAD products. Use the prescribed remote
control of the specific NAD product for a full compliment of the
applicable remote control buttons.
IDENTIFICATION OF CONTROLS
SR 8 REMOTE CONTROL
13