Troubleshooting - ZyXEL Communications ZYWALL USG 300 Quick Start Manual

Port Interface Zone
1 ge1
2, 3 ge2, ge3
4, 5 ge4, ge5
6 ge6
7 ge7
AUX aux
CONSOLE N/A
Label
1~7
AUX, CONSOLE
Note: The USB ports and extension card slots are reserved for future use.

7 Troubleshooting

Problem Corrective Action
None of the LEDs Make sure that you have the power cord connected to the ZyWALL and plugged in to an
turn on. appropriate power source. Make sure you have the ZyWALL turned on. Check all cable
connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you should
contact your local vendor.
IP Address and DHCP Settings
LAN 192.168.1.1, DHCP server enabled Protected LAN
WAN DHCP clients
DMZ None, DHCP server disabled
WLAN 10.59.0.1, DHCP server enabled
None None, DHCP server disabled
None None
None None
Type Cable to Use
RJ-45 8-wire Category 5e or above Ethernet cable
RS-232 RS-232
ENGLISH
7
Suggested Use With Default Settings
Connections to the Internet
Public servers (such as web, e-mail and
FTP)
Wireless access points
Optional
Auxiliary modem
Local management