Power Supply; Adjusting The Sound; Tuner Operation - LENCO SCD-30 Instruction Manual

POWER SUPPLY
USING HOUSE CURRENT
Before use, check that the rated voltage
of your unit matches your local voltage.
USING BATTERIES
Disconnect the AC power cord from the AC inlet of the
unit. Battery power is cut automatically by the cord while
it is connected.
battery door
FOR BETTER RECEPTION
FM
TURN ON / OFF THE SYSTEM
Press the ON/ STANDBY button to turn the audio on. To change the audio mode between,
CD , U DISK and TUNER press FUNTION button while the power is on. the audio
mode is displayed.
Power will be cut off automatically when CD, MP3 and USB function in stop mode for 15 minutes.
ADJUSTING THE SOUND
VOLUME
VOLUME
TUNER OPERATION
Tuning a RADIO Station
1. Press FUNCTION button repeatedly
until "TUNER" is shown.
2. Press the BAND/FOLDER button
to select the desired frequency band (FM or AM).
3. Press the TUNE + /NEXT or
TUNE - /BACK button as many times
as required to tune in to the
desired station.
4. Press and hold the TUNE +/NEXT or
TUNE - /BACK button for more than 1 second,
scanning starts automatically and tuner stops at the
first receivable broadcast station.
5. To stop the auto tuning, press the TUNE +/NEXT or
TUNE - /BACK button again.
When the volume decrease, or the sound distorts, replace
all of the batteries with new ones.
Insert 8 UM-2 ( size C ) batteries.
Press volume +/- to adjust volume level.
FOR PRIVATE LISTENING
Plug in headphones (ø3.5 mm stereo mini-plug) to the PHONES jack.
When headphones are plugged in, the speakers are automatically disconnected.
Selecting FM Stereo/Mono mode
1. To select FM stereo/mono mode, press ST/MONO
button on the remote control.
2. "STEREO" icon will be lit on when receiving station is
broadcasted in Stereo.
3. To select mono mode, press ST.MONO button again.
4. "STEREO" icon will never turn on in FM MONO mode.
GB 1
To AC socket
To AC outlet
AM