Setting The Clock; Listening To Radio - LENCO MCI-400 - V1.0 Instruction Manual

II) WIRE CONNECTION
1) CONNECT THE END OF THE SPEAKER CABLE
TO THE SPEAKER OUT TERMINAL (RED & WHITE HEAD)
(25) AT THE BACK OF MAIN UNIT, ANOTHER
TERMINAL CONNECT TO THE SPEAKER CLIP OF THE
SPEAKER BOX BACK SIDE(RED COLOR OF SPEAKER
CABLE TO RED COLOR OF SPEAKER CLIP)
2) CONNECT ONE END OF THE RCA CABLE (YELLOW
HEAD)
TO THE SUB-WOOFER OUT JACK (27) AT THE BACK OF
MAIN UNIT TO THE SUB-WOOFER IN JACK (31) AT THE
BACK OF THE SUB-WOOFER
3) CONNECT THE 75 OHM ANTENNA JACK(26) VIA A 75
OHM
CABLE(NOT PROVIDED) TO GET THE FM RECEPTION
III) POWER SUPPLY
CONNECT THE AC POWER CORD FROM THE MAIN UNIT(28) AND AC POWER CORD FROM SUB-WOOFER UNIT(30)TO
THE MAIN POWER SUPPLY FROM YOUR HOME AREA. TURN ON THE ON/OFF BUTTON AT MAIN UNIT (15) AND POWER
ON THE SUB-WOOFER (14) RESPECTIVELY. IF THE LCD DISPLAY (2) AND THE POWER LED (14) IS LIGHT UP WITH
BLUE LIHGT. IT MEANS THE SYSTEM IS NOW READY TO PLAY THE MUSIC.

SETTING THE CLOCK

1. SET UNIT IN STANDBY MODE.
2. PRESS THE "MEM/CLK-ADJ" BUTTON (17) ONCE, THE LCD DISPLAY (2) WILL SHOW " 24 HR ". PRESS SKIP
SKIP BUTTON (10) TO SELECT THE APPROPIATE AREA HOUR FORMAT(12HR/24HR). PRESS "MEM/CLK-ADJ"
BUTTON (17) AGAIN TO CONFIRM.
3. THEN FIRST DIGIT OF "0:00" ON DISPLAY(2)(IF SELECT 24HS MODE) IS FLASHING. PRESS SKIP
BUTTON (10) TO SET THE CORRECT HOUR. PRESS "MEM/CLK-ADJ" BUTTON (17) TO STORE THE CORRECT
HOUR.
4. THE THIRD & FOURTH DIGIT OF "0:00" IS FLASHING, PRESS THE SKIP
CORRECT MINUTES. THEN PRESS "MEM/CLK-ADJ" (17) TO STORE THE CORRECT MINUTE.
THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF DIS-CONNECTING THE MAIN POWER SUPPLY.
YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY MODE FOR CONVENIENCE
USAGE.

LISTENING TO RADIO

MANUAL TUNING
1. PRESS FUNCTION BUTTON (16) TO SELECT " TUNER " MODE.
2. TUEN TO THE DESIRE STATION BY PRESSING THE SKIP/TUNE
3. ADJUST THE MAIN VOLUME CONTROL (3) AND SUB-WOOFER VOLUME (29) TO THE DESIRED VOLUME AND BASS
EFFECT LEVEL.
AUTO TUNING
1. PRESS FUNCTION BUTTON (16) TO SELECT " TUNER " MODE.
2. PRESS AND HOLD THE SKIP/TUNE
RELEASE.
3. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP UNTIL A RADIO STATION IS REACHED.
4. REPEAT STEP 3 & 4 UNTIL THE DESIRED RADIO STATION IS BEING REACHED.
5. ADJUST THE MAIN VOLUME CONTROL (3) AND SUB-WOOFER VOLUME (29) TO THE DESIRED VOLUME AND BASS
EFFECT LEVEL.
OR SKIP/TUNE
OR SKIP/TUNE BUTTON (10) FOR 1-2 SECONDS AND THEN
E-4
OR SKIP BUTTON (10) TO SET THE
BUTTON (10).
OR
OR SKIP