Getting Started; Placing The Back-Up Battery; Connecting The Speakers; Placing The Remote Control Battery - LENCO MC-144 User Manual

Getting started

Placing the back-up battery

This unit has a back-up battery for not losing the clock settings while turning the main power
switch into OFF position. To place the back-up battery;
On the back side of the main remove the back-up battery door (24).
•
Insert a "CR2500" Cell size battery into the battery compartment. Be sure that the batteries are
•
inserted correctly to avoid damage.
Close the battery compartment.
•

Connecting the speakers

1. Unwind the speaker cable.
2. Connect the cable of the left speaker to the white colored connector (19) on the backside
of the unit.
3. Connect the cable of the right speaker to the red colored connector (19) on the backside
of the unit.

Placing the remote control battery

Insert a "CR2500" Cell size battery into the battery
compartment. Be sure that the batteries are
inserted correctly to avoid damage to the remote
control. Always remove the batteries when the
remote control will not be used for a long period of
time, as this will cause leakage to the batteries
and subsequently damage to the remote control.
Note: The unit must be "ON" and in CD/USB/AUX
mode for the remote control to operate.

Connecting the AC power cord

Make sure that the power switch on the back side of the main unit (18) is in "OFF" position. Now
you can unwind the AC power cord. Insert the end of the AC power cord into the wall outlet.
Important: Before disconnecting the AC power cord from the wall outlet you need to place the
power switch in "OFF" position.

General operation

Turn the unit ON / OFF

Switch the power switch (18) on the back side of the main unit in ON position to turn on the main
unit. Switch it back in OFF position to turn OFF the main unit.

Setting the clock

To set the time:
1. Press the "TIME SET" button. (Do not release "TIME SET" button during time setting)
2. Press the "HOUR" button to adjust the hours.
3. Press the "MINUTE" button to adjust the minutes.
4. Release all button to confirm the set time.
The set time will now be displayed.
7