Operating Notes - AKG HEARO 999 AUDIOSPHERE User Instructions

2 Description
2.3.2 Charger
Fig. 2: Charger

3 Operating Notes

3.1 Charging Batteries
inside the Headphones
WARNING:
3.3 Discharging
Batteries
3.4 Replacing Batteries
7. Charging cable
8. Status LED
Therefore, charge the supplied batteries before first operating
your headphones system.
If you operate the headphones on dry batteries, never try to charge the
batteries using the supplied charger. This would cause serious damage to your
headphones. Dispose of dead batteries conforming to local waste disposal
rules.
1. Use the POWER switch (1) to switch the headphones off.
When the power is off, the POWER LED (2) will be dark.
2. Plug the charging cable (7) into the charging socket (3) on the headphones.
3. Check that the AC voltage stated on the charger is the same as that availa-
ble in your country. If it is, connect the charger to a convenient AC outlet.
The status LED (8) will light to indicate the batteries inside the headphones are being
charged.
The batteries will be fully charged after approximately 14 hours.
4. Unplug the charging cable (7) from the headphones and disconnect the charger from the
power outlet.
The capacity of any rechargeable battery will decrease over time. If you feel that you need to
recharge the supplied batteries more often than would be convenient, you may consider
Fig. 3: Removing ear pads.
7
8
replacing the batteries with new
AAA size 1.2 V rechargeable or
1.5 V alkaline dry batteries.
1. Remove the ear pad from the
left-hand earphone
shown in fig. 3.
2. Remove the old batteries.
as