Cable Box - Sony BRAVIA KDL-32XBR950 Operating Instructions Manual

Cable Box

Notes on Using This Connection
To Do This ...
Use the cable box
Set up the remote control to
operate the cable box
Activate the remote control to
operate the cable box
Prevent the accidental switching
of TV channels
32
For best results, use this connection if:
s
Your cable company scrambles all channels, which requires you to use a
cable box.
s You do not have a VCR. (If you have a VCR, see pages 34 and 36.)
With this connection you can:
s
Use the remote control to change channels coming through the cable
box to the TV's VHF/UHF jack. (You must first program the remote
control for your specific cable box, see page 60.)
About Using This Connection with Dual Picture (Twin View, etc.) Features
With this connection, all channels come into the TV through your cable box and
only one unscrambled signal is sent to the TV, so you cannot use the dual picture
features. If some of your channels are scrambled, but others are not, consider using
the "Cable Box and Cable" connection on page 31 instead.
To connect the cable box
1
Connect the CATV cable to the cable box's input jack.
2
Use the supplied antenna cable to connect the cable box's output jack to
the TV's VHF/UHF jack.
3
Run the Auto Setup program, as described in "Setting Up the Channel
List" on page 55.
Antenna cable
CATV
(supplied)
cable
IN OUT
Cable Box
Do This ...
Tune the TV to the channel the cable box is set to (usually channel 3 or 4) and then
use the cable box to switch channels.
Program the remote control. See "Programming the Remote Control" on page 60.
Press FUNCTION repeatedly until the
When using the cable box, you need the TV to stay on the channel the cable box is
set to (usually channel 3 or 4). You can use the TV's Channel Fix feature to lock in a
specific channel. For details, see "Using the Channel Menu" on page 110.
Rear of Media
Receiver Unit
VHF/UHF
SAT/CABLE indicator lights up.