Sanyo VCC-HD2100 User Manual page 97

If you are operating the camera for the first time, check the factory default alarm detection conditions on the
ALARM SETTINGS screen. Change the default settings as desired.
For details, refer to the "ALARM SETTINGS" section.
You can configure the camera to detect alarm conditions via the "alarm input terminals" or "built-in motion sensor".
For how to configure the camera to detect alarm conditions via the alarm input terminals, refer to the "Alarm
Input/Output Terminal Connections" section.
Connecting an alarm switch, infrared sensor, or other external device to the ALARM IN1/2 terminal enables the
camera to detect alarm conditions such as entry of an intruder.
Setting Item
ALARM IN1/2 (Alarm input
terminal number)
POLARITY (Signal polarity)
DURATION (Alarm retention
duration)
The camera uses the built-in motion sensor to detect alarm conditions.
The motion sensor detects an alarm condition in two ways as follows.
Setting Item
MOTION (Use of built-in
motion sensor)
DURATION (Alarm retention
duration)
A Disabling motion detection in masked areas
Default Setting
OFF (Disables alarm detection.)
NO (Ex.: Detects an alarm when
door is closed)
5SEC (Ex.: Records alarm video
for 5 sec.)
Default Setting
OFF (Disables alarm
detection.)
5SEC (Ex.: Records alarm
video for 5 sec.)
Optional Setting
ON (Enables alarm detection.)
NC (Ex.: Detects an alarm when door is opened.)
10SEC to 5MIN, CC (Retains the alarm state as long
as the alarm signal persists.)
Optional Setting
A
MASKING
B
DETECT
10SEC to 5MIN, CC (Retains an alarm state as long as
the motion alarm persists.)
Quick Operation Guide 5/10