Samsung PL-50P3H Owner's Instructions Manual page 9

Put the 4 pegs on the PDP in the grooves of the wall mount bracket and pull down on
4
the PDP (Œ) to secure it to the wall mount bracket. (´) Tighten the screws as shown
(ˇ) so that the PDP cannot be separated from wall mount bracket.
PL50P3H
PDP panel
Wall attachment
panel bracket
PL63P3H
PDP panel
Wall attachment
panel bracket
16
Wall
Wall
How to Adjust Mounting Angle
Notice : Please secure the mounting bracket on the wall surface after setting its angle at 0° Notice
Factory default
PL50P3H PL63P3H
The wall mount bracket is delivered separately.Please tighten the captive screw in the direction of
the arrow after assembling the bracket.
Changeing the angle
1 Secure the PDP to the wall mount
bracket.(Please refer to the following
instructions.)
2 Set the angle by pulling the upper end of
the PDP attached to bracket in the direction
of the arrow.
3 The angle can be adjusted from 0° to 20°
by ±2°.
1. Contact an authorized technician when installing the wall attachment panel.
2. After hanging the PDP panel on the wall attachment panel, make sure that
the Insulation holders are completely hung.
3. Be careful so that fingers are not caught.
4. Make sure the wall attachment panel brackets are tightened.
Otherwise, the PDP panel may fall down and you might be hurt.
17