troubleshooting for anynet
Symptom
anynet + does not work.
I want to start anynet + .
I want to exit anynet + .
the message Connecting to
anynet + device... appears on the
screen.
the anynet + device does not play. You cannot use the play function when Plug & Play is in progress.
the connected device is not
displayed.
the tV program cannot be
recorded.
+
Solution
Check if the device is an Anynet + device. The Anynet + system supports Anynet +
■
devices only.
■
Connect only one receiver (home theater).
Check if the Anynet + device power cord is properly connected.
■
Check the Anynet + device's Video/Audio/HDMI 1.3 cable connections.
■
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
■
■
Check whether the TV remote control is in TV mode.
Check whether it is Anynet + exclusive remote control.
■
Anynet + doesn't work at a certain condition. (Searching channels, Operating
■
WISELINK, Plug & Play)
■
When connecting or removing the HDMI 1.3 cable, please make sure to search
devices again or restart your TV.
Check if the Anynet + Function of Anynet + device is set on.
■
Check if the Anynet + device is properly connected to the TV and check if the Anynet +
■
(HDMI-CEC) is set to On in the Anynet + Setup menu.
■
Press the tV button on the TV remote control to switch to TV. Then press the toolS
button to show the Anynet+ menu and select a menu you want.
■
Select View tV in Anynet+ menu.
■
Press the SourCE button on the TV remote control and select a device other than
Anynet + devices.
■
Press any of Ch /
and PrE-Ch to change the TV mode.
(Note that the channel button operates only when a tuner-embedded Anynet + device
is not connected.)
You cannot use the remote control when you are configuring Anynet + or switching to a
■
view mode.
Use the remote control when the Anynet + setting or switching to view mode is
■
complete.
Check whether or not the device supports Anynet + functions.
■
■
Check whether or not the HDMI 1.3 cable is properly connected.
Check whether Anynet + (HDMI-CEC) is set to On in the Anynet + setup menu.
■
Search Anynet + devices again.
■
You can connect an Anynet + device using the HDMI 1.3 cable only. Some HDMI
■
cables may not support Anynet + functions.
■
If it is terminated by an abnormal situation such as disconnecting the HDMI 1.3 cable
or power cord or a power failure, please repeat the device scan.
Check whether the antenna jack on the recording device is properly connected.
English -