Rear Panel Jacks - Samsung HL-S5088W Owner's Instructions Manual

Your New Wide TV

Rear Panel Jacks

ΠCableCARD
TM
Insert a CableCARD into the slot. (Refer to page 22)
´ S-VIDEO INPUT jacks
Connects an S-Video signal from an S-VHS VCR or DVD player.
(Refer to page 21)
ˇ VIDEO/AUDIO INPUT jacks
Connect video/audio signals from external sources, such as VCR
or DVD players. (Refer to pages 21 and 25)
¨ VIDEO/AUDIO OUTPUT jacks
Sends video/audio signals from the TV to an external source,
such as a VCR. These jacks are available only in TV, Video and
S-Video modes. (Refer to pages 21 and 27)
ˆ COMPONENT IN 1, 2 jacks (Y, P
Use these jacks to connect the component video/audio signals
from a DVD player or a Set-Top Box. (Refer to pages 24 and 26)
Ø PC VIDEO INPUT jack
Connect to the video output jack on your PC.
∏ PC AUDIO INPUT jack
Connect to the audio output jack on your PC.
(Refer to page 132)
" HDMI (High Definition Multimedia Interface)
INPUT jacks (HDMI IN 2)
Connect to the HDMI jack of a device with HDMI output.
' HDMI (High Definition Multimedia Interface)/
DVI INPUT jack (HDMI 1/DVI IN)
Connect to the HDMI jack of a device with HDMI output.
These inputs can also be used as a DVI connection with separate
analog audio inputs. An optional HDMI/DVI cable will be
necessary to make this connection. When using an optional
HDMI/DVI adapter, the DVI analog audio inputs on your TV allow
you to receive left and right audio from your DVI device.
(Not compatible with PC) (Refer to pages 24 and 27)
English - 14
˝ DVI AUDIO (L/R) IN
Connect to the DVI audio output jack of an external device.
(Refer to page 26)
Ô DIGITAL AUDIO OUT (OPTICAL) jack
Connect to a Digital Audio Component. (Refer to page 28)
 G-LINK
Connect the IR controller cable to the G-LINK
Ò RS232C
Connection for professional linking network and service usage.
Ú D-Net (IEEE1394) S400 MPEG
Connect to external IEEE1394 digital products such as digital
VCRs and camcorders. Two jacks are provided for this purpose,
which allow for a high degree of flexibility for connecting your
, P , AUDIO L/R)
B R
D-Net controlled system. (Refer to pages 116~130)
Æ ANTENNA terminals
Two independent cables or antennas can be connected to
these terminals. Use "ANT 1 IN (CABLE)" and "ANT 2 IN (AIR)"
terminals to receive a signal from VHF/UHF antennas or your
cable system. (Refer to pages 18~20)
ı POWER IN
Connect the supplied power cord.
TM
TM terminal on your TV.