Rear Panel Jacks - Samsung HL-R4667W Owner's Instructions Manual

Your New Wide TV

Rear Panel Jacks

Use the rear panel jacks to connect components such as a VCR. You can connect different components
such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and
two sets of component video input jacks on the rear panel of your TV. For more information, see
"Connections".
ΠANTENNA terminals
Two independent cables or antennas can be connected to
these terminals. Use "ANT 1 IN (CABLE)" and "ANT 2 IN (AIR)"
terminals to receive a signal from VHF/UHF antennas or your
cable system. (Refer to pages 18~20)
´ SERVICE
This jack is for software upgrades.
ˇ S-VIDEO INPUT jacks
Connects an S-Video signal from an S-VHS VCR or DVD player.
(Refer to page 23)
¨ DVI (Digital Video Interface) AUDIO INPUT jacks
Connect to the digital audio output jacks of a device with DVI
output. (Refer to page 25)
ˆ PC AUDIO INPUT jacks
Connect these to the audio output jacks on your PC.
(Refer to page 122)
Ø VIDEO/AUDIO INPUT jacks
Connect video/audio signals from external sources, such as VCR
or DVD players. (Refer to page 24)
∏ VIDEO/AUDIO OUTPUT jacks
Sends video/audio signals from the TV to an external source,
such as a VCR. These jacks are available only in RF, Video and
S-Video modes.
" COMPONENT1, 2 jacks (Y, P
Use these jacks to connect the component video/audio signals
from a DVD player or a Set-Top Box. (Refer to pages 24~25)
English - 14
' DIGITAL AUDIO OUT (OPTICAL) jack
˝ G-LINK
Ô Anynet
 PC VIDEO INPUT jack
Ò HDMI (High Definition Multimedia Interface)/
Ú D-NET (IEEE1394) S400 MPEG
Æ CableCARD
, P L, R)
B R,
Connect to a Digital Audio Component. (Refer to page 27)
TM
Connect the IR controller cable to the G-LINK
your TV.
Please refer to the Anynet Owner's Instruction. This jack is for
connecting to other Samsung Anynet-enabled devices.
Connect these to the video output jack on your PC.
DVI INPUT jack
Connect to the HDMI jack of a device with HDMI output.
These inputs can also be used as a DVI connection with separate
analog audio inputs. An optional HDMI/DVI cable will be
necessary to make this connection. When using the optional
HDMI/DVI adapter, the DVI analog audio inputs on your TV
allow you to receive left and right audio from your DVI device.
(Refer to pages 25~26)
Connect to external IEEE1394 digital products such as digital
VCRs and camcorders.
Two jacks are provided for this purpose, which allow for a high
degree of flexibility for connecting your D-Net controlled system.
TM
Insert the CableCARD into the slot. (Refer to page 22)
terminal on
TM