Selecting The Cassette Playback Mode/Repeat A B Function; Timer Function - Samsung MM-KT8 Instruction Manual

Selecting the cassette Playback
Mode/Repeat A B Function
Selecting the Cassette Playback Mode
Your micro component system has three cassette playback
modes which enable you to listen to both sides of a cassette
automatically.
Press REV.MODE until the appropriate
symbol is displayed.
•
When the display indicates...The micro component system plays back
One side of the selected cassette and then stops.
One side of the cassette.
The other side of the cassette and then stops.
Both sides of the cassette indefinitely until
you press stop.
REPEAT A B Function
Press REP. A B button.
•
Use this to listen to a specific section again during playback.
•
Set the start and end points of the section you want to repeat 3 times.
•
This is a useful when learning a foreign language.
•
The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Note
•
You cannot set the end point (B) within 7 seconds after
setting the start point (A).
63
Example: You wish to wake up to music every morning.
1
CANCLE
RESERVE
REMAIN
4
a. Set the hour by pressing
b. Press ENTER.
c. Set the minutes by pressing
d. Press ENTER.
FAVORITE SONG SEARCH SONG
KEY CONTROL TUNING MODE SLOW
b #
TEMPO TUNER MEMORY LOGO
+
-
FEMALE
MALE STEP
7
•
•
•
• USB
•

Timer Function

•
The timer enables you to switch the system on or off at specific times.
•
If you no longer want the system to be switched on or off automatically, you must cancel the timer.
•
Before setting the timer, check that the current time is correct.
•
For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
Press
Switch the system 2
TIMER/CLOCK
on by pressing
until TIMER is
POWER.
displayed.
5
Set the timer
Set the timer
switch-off time.
switch-on time.
or a. Set the hour by pressing
button. button.
b. Press ENTER.
• •
The minutes flash. The minutes flash.
or c. Set the minutes by pressing
button. button.
d. Press ENTER.
• •
OFF TIME is displayed (instead VOL 20 is displayed, where 20
of the equalizer symbols) for a few corresponds to the volume
seconds, followed by any switch- already set.
off time already set; you can now
set the timer switch-off time.
Press or button
Press ENTER to
8
to select the source to
confirm the timer.
be played when the
system switches on.
TAPE (cassette) : Insert a cassette tape.
TUNER (radio) : a Press ENTER.
b Select a preset station
by pressing
Tuning or .
CD (compact disc) : Load a compact
disc.
:connect the USB.
Note
If the timer switch on and off times are identical, the word ERROR is displayed.
Press the ENTER
3
button.
•
ON TIME is displayed (instead
of the equalizer symbols) for a
few seconds, followed by any
switch-on time already set; you
can set the timer switch-on time.
Press or button
6
to adjust the volume
level and press
ENTER.
•
or The source to be selected is
displayed.
or
Press POWER to
9
set the system to
standby mode.
•
is displayed to the top-right
of the time, indicating that the
timer has been set.
•
The system will switch on and off
automatically at the required
times.
64