Checking The Output Sound (Sound Check) - Roland VP-550 Owner's Manual

Checking the output sound
Here's how you can record and play back the sound that's being sent from the [OUTPUT] jacks. While you're
using a mic, it's diffi cult for you to tell exactly what the audience is really hearing, but this function provides
an easy and accurate way of checking the output sound.
1.
Press the [REC] button to start recording.
The sound being sent from the [OUTPUT] jacks will be recorded.
The [REC] button will light red during recording.
Maximum recording time is ten seconds.
2.
Start performing.
3.
To stop recording, press the [REC] button once again.
Alternatively, recording will automatically stop after ten seconds.
If you press the [PLAY] button during recording, recording will stop and playback will begin.
4.
Press the [PLAY] button to play back the recorded sound.
The [PLAY] button will light green during playback.
5.
Press the [PLAY] button once again to stop playback.
Alternatively, playback will automatically stop when it ends.
If you press the [REC] button during playback, playback will stop and recording will begin.
*
The recorded sound is lost when you turn off the power.
34
( SOUND CHECK)
When you've held down the [PLAY]
button for approximately two sec-
onds, the button will blink, and loop
playback will begin.