Panasonic PT-LB2U Operating Instructions Manual page 12

Details of your projector (continued)
Rear and bottom view
①
③
① Terminals
② Remote control signal receptor
③ AC IN
Connect the power cord to supply electric power to
the projector. (  page 18)
④ Air intake port
⑤ Front leg adjuster
To adjust the projection angle. (  page 22)
NOTE:
• Do not connect any power cable other than the attached one.
• Do not cover the ventilation openings of the air intake port or air outlet port.
Terminals
① Connect to a network cable.
(See "Network Operation Manual".)
② Connect to a computer to control the projector's
operation.
(  page 17, 51)
③ Connect to a computer or YP
(  page 17)
④ Connect to an S-VIDEO signal cable.
(  page 16)
NOTE:
• Do not place your hands or other objects close to the air outlet port as this may cause damage or injury.
• Do not place your hands or face, or objects which cannot withstand heat near the air outlet port. Hot air comes out
from this port.
12  ENGLISH
②
④
① ② ③
COMPUTER 1 IN
SERIAL
LAN
COMPUTER 2 IN
P signal cable.
B R
⑤ ⑥ ⑦
⑥ Rear leg adjuster
To adjust the projection angle. (  page 22)
⑦ Burglar hook port
Attach a commercial burglar prevention cable.
⑧ Air outlet port
Hot air comes out from this opening.
⑨ Speaker
⑩ Lamp unit compartment (  page 46)
④
S-VIDEO
AUDIO
IN
OUT
⑦
⑥
1 2
VIDEO IN AUDIO IN
⑤
⑤ Connect to a VIDEO signal cable.
(  page 16)
⑥ Connect audio cables for inputting audio signal.
(  page 17)
⑦ Connect an audio cable for audio signal output
to the connected equipment. If it is connected to
this terminal, no sound comes out of the built-in
speaker.
(  page 16, 17)
⑩
⑨
⑧