Connections; Audio Out Terminals Connection - Panasonic Viera TH-103PF10 Operating Instructions Manual

Connections

AUDIO OUT Terminals connection

Speakers (Optional accessories)
AC cord connection (see page 13)
– AC cord fi xing
Note:
Make sure that the
AC cord is locked on both
the left and right sides.
– Cable fi xing bands – Cable fi xing bands
Secure any excess cables with bands as required. Secure any excess cables with bands as required.
Pass the attached cable Pass the attached cable
fi xing band through the clip fi xing band through the
as shown in the fi gure. clip as shown in the
fi gure.
1
SLOT1
Optional Terminal Dual HDMI Terminals
(equivalent of Dual
Board Insert Slot
HDMI Terminal Board
(covered)
(TY-FB10HMD))
(see page 12)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AC cord connection (see page 13)
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2 Fix the AC cord with
the clamper.
To secure cables connected to Terminals, wrap the cable fi xing band around them then To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure. pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band. in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of BNC Component Video
Terminal Board (TY-42TM6A))
(see page 12)
R
AUDIO OUT
Close
Push until
the hook clicks.
Open
2. Pull off.
1. Keep the
knob pressed.
To loosen: To loosen:
To tighten: To tighten:
Push the catch Push the catch
Pull
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 10)
L
Stereophonic sound code
audio equipment
line-in
Unplug the AC cord
Close
Unplug the
AC cord
Open
pressing the
two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
Pull
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 11)
R L
AUDIO OUT
From input
on audio
amplifi er
(see page 9)
9