Olympus CAMEDIA C-60 Zoom Reference Manual page 151

Troubleshooting
Possible cause
The picture is too bright
The aperture value is small
in the A (M) mode.
The shutter speed setting
is too slow in the S (M)
mode.
The picture is too dark.
The flash was blocked by
your finger.
The subject was out of the
working range of the flash.
The flash was set to the
flash off mode
The subject was too small
and was backlit.
The sequential shooting
mode was used.
The center of the subject is
too bright.
10
The aperture value setting
is too high in the A (M)
mode.
The shutter speed setting
is too fast in the S (M)
mode.
150
Corrective action
Increase the aperture value. Or
set the camera to the P mode.
Increase the shutter speed or
set the camera to the P mode.
Hold the camera correctly,
keeping your fingers away from
the flash.
Shoot within the flash working
range.
Select a flash mode other than
. flash off
Set the flash to fill-in mode
use the spot metering mode
Higher shutter speeds are used
when the sequential shooting
mode is selected, which may
result in pictures that are darker
than usual. Set DRIVE to
the MODE MENU.
If the center of the subject is too
bright, the image as a whole
emerges darker. Adjust the
exposure compensation toward
plus (+).
Decrease the aperture value or
set the camera to the P mode.
Decrease the shutter speed or
set the camera to the P mode.
.
, or
in
Ref. Page
P. 58
P. 59
P. 39
P. 55
P. 55
P. 55, 62
.
P. 68
P. 84
P. 58
P. 59