Performance Data Sheet - LG LFX28979 Owner's Manual

38
MAINTENANCE
Models Number 5231JA2002A-S
This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to
the permissible limit for water leaving the system as specified in NSF/ANSI 42.
System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine
Taste and Odor and Nominal Particulate Class III.
Capacity: 500 gal (1,892 L)
Substance
Concentration
Nominal Particulate Class I
Particle size: >0.5 to < 1 um
Chlorine taste and odor
Class III
Note that while the testing was performed under standard laboratory conditions, actual performance may vary.
Application Guidelines/Water Supply Parameters
Service Flow
Water Pressure
Water Temperature 36 °F - 100 °F (0.6 °C - 37.8 °C)
WARNING
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system.
Systems must be installed and operated in accordance with
manufacturer's recommended procedures and guidelines.
Warranty: See Warranty Card for Details.
For a replacement cartridge or for service
contact your local dealer.
You can also visit our website; www.lg.com
or call 1-877-714-7486.
Manufactured for LG® Electronics by:
CUNO Incorporateda 3M Company 400 Research Parkway
Meriden, CT 06450 U.S.A.
Telephone: 203-237-5541
Fax: 203-238-8701

Performance Data Sheet

Average Influent Challenge
Influent Concentration. Units apply to each
row
24,333 At least 10,000 particles/ml
1.9 2.0 mg/L ± 10%
0.5 gpm (1.89 lpm)
20 -125 psi (138 – 862 kPa)
Use with replacement cartridge 5231JA2002A
Average Product
Average %
Water
Reduction
Concentration
915 96
0.07 96.4
CAUTION
To reduce the risk of property damage due to water
leakage:
• Read and follow. Use instructions before installation and
use of this system.
• Install on COLD water lines only.
• Comply with all state and local plumbing codes.
• Install a pressure limiting device and water hammer
arrester for inlet water pressures exceeding 80 psi (552
kPa). Refer to Uniform Plumbing Code, Sections 608.2 and
609.10).
• Never install or operate where inlet water pressure may
exceed 125 psi (862 kPa).
• Protect filter from freezing. Remove filter in temperatures
below 33°F (0.6°C).
• Replace cartridge at specified service interval. Cartridge
MUST be replaced at least every 12 months.
NSF % reduction req. or
Max. permissible product
water concentration
≥ 85%
≥ 50%