Connection Panel - LG LST-3410A Owner's Manual

Connection Panel

ANT IN
Connect to over-the-air outdoor/indoor antenna.
G-LINK
®
Gemstar cable box control connector. Connect G-LINK cable (supplied with your HD DVR) to
control a Cable Box using the TV Guide On Screen™ feature.
Note: If there is a "demo pin" in the jack, remove it to disable demo mode.
AUDIO/VIDEO INPUT 1, 2
Connect audio/video output of an external source (Audio system, TV/Monitor,
VCR, Camcorder).
CABLE IN
Connect to cable TV (CATV) signal source.
VIDEO OUT 1, 2
Connect to TV/Monitor with composite video inputs.
COMPONENT OUTPUT
Connect to TV/Monitor with YPbPr inputs.
DIGITAL AUDIO OUT (OPTICAL)
Connect to digital (optical) audio equipment.
AUTHORIZED SERVICE ONLY
Is used only for authorized service purposes.
RGB OUT
Connect to TV/Monitor with RGB input.
Variable "volume" AUDIO OUT (Left/Right)
Connect to a TV, amplifier, receiver or stereo system.
You can adjust the volume of this audio out on HD DVR.
Fixed "volume" AUDIO OUT (Left/Right)
Connect to a TV, amplifier, receiver or stereo system.
You cannot adjust the volume of this audio out on HD DVR.
S-VIDEO OUT
Connect to TV/Monitor with S-Video
input.
DVI OUT
Connect to TV/Monitor with DVI port.
AC Power Cord
Plug into the power source.
IEEE-1394
Connect to IEEE-1394 equipment.
Do not touch the inner pins of the
jacks on the rear panel.
Electrostatic discharge may cause
permanent damage to the unit.
9