Chapter 13— Configuration/Control Commands
156
getvar result
Returns the LEAP password.
Example
Description
Syntax
Result
setvar choices
4 to 32 ASCII characters. Default = password
Example
Description
Syntax
Result
wlan.leap_username
Type: getvar; setvar
This parameter refers to the LEAP user name. The user name must
correspond to a user profile established on the RADIUS/AAA server in
use.
getvar result
Returns the LEAP user name.
Example
Description
Syntax
Result
setvar choices
0 to 32 ASCII characters. Default = user
Example
Description
Syntax
Result
wlan.operating_mode
type: getvar; setvar
This parameter refers to the Network Operating mode. Infrastructure
mode means that the printer tries to associate with an access point. Ad
Hoc mode means that the printer tries to associate with a device other than
an access point and join a stand alone network.
To configure the printer for Ad Hoc mode
1 Set the eSSID to the new network's eSSID.
2 Turn off DHCP and assign an IP address to the printer.
3 Set the subnet mask on the printer to the new network's subnet mask.
4 Change the Network Operating mode on the printer to ad hoc.
EasyCoder PL-Series Printer Programmer's Reference Manual
Get the LEAP password.
! U1 getvar "wlan.leap_password"
"password"
Set the LEAP password to password.
! U1 setvar "wlan.leap_password"
"password"
Sets the LEAP password to password.
Get the LEAP user name.
! U1 getvar "wlan.leap_username"
"user"
Set the LEAP user name to user.
! U1 setvar "wlan.leap_username" "user"
Sets the LEAP user name to user.