Using The Remote Control - InFocus IN3902LB User Manual

Using the remote control

The remote uses two (2) provided AA batteries. They are easily installed by
removing the cover from the remote's back, aligning the + and - ends of the
batteries, sliding them into place, and then replacing the cover.
Caution:
• When replacing the batteries, be aware that using batteries other than
the type provided with the projector may risk severe damage to the
remote.
• When disposing of the batteries, be sure to do so in an enviromentally
proper manner.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the batteries' polarity (+/-) is aligned correctly.
• Do not mix new and old batteries together, or mix different types of
batteries together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing or not in use
for a prolonged period.
The remote also has:
• Volume buttons to adjust the sound.
• Custom button that can be assigned to a special function, like Blank
Screen or Freeze (on page 34).
• Source button to switch between sources.
• Blank button to blank the screen.
• Presets button to select stored settings (on page 32).
• Mute button to silence the audio.
• Auto Image button to resynch the projector to the source.
• Resize button to switch among aspect ratios (on page 32).
Troubleshooting the remote
• Make sure the batteries are installed in the proper orientation and are
not dead.
• Make sure you're pointing the remote at the projector or the screen, not
the computer, and are within the remote range of 15 feet (4.5m). For
best results, point the remote at the projector.
navigation
buttons
26