Image Menu; Ver Scan - Hitachi CP-X505 User Manual – Operating Manual

IMAGE Menu

From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the item. Then perform it
according to the following table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
(continued on next page)
Using the ▲/▼ buttons switches the mode for aspect ratio.
For an RGB signal
NORMAL ó 4:3 ó 6:9 ó SMALL
For an M1-D signal
NORMAL ó 4:3 ó 6:9 ó 4:9 ó SMALL
For a Video signal, S-video signal or Component video signal
4:3 ó 6:9 ó 4:9 ó SMALL
For no signal
4:3 (fixed)
• The NORMAL mode keeps the original aspect ratio of the signal.
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• Over-adjusting the vertical position may cause noise to appear
on the screen. If this occurs please reset the vertical position to the
default setting. Pressing the RESET button when the V POSITION
is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal,
or component video signal of 55i (480i) or 65i (576i), the range of
this adjustment depends on the OVER SCAN (above) setting. It is
not possible to adjust when the OVER SCAN is set to 0.
Using the ▲/▼ buttons adjusts the horizontal position.
Left ó Right
• Over-adjusting the horizontal position may cause noise to appear
on the screen. If this occurs please reset the horizontal position to the
default setting. Pressing the RESET button when the H POSITION is
selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal,
or component video signal of 55i (480i) or 65i (576i), the range of
this adjustment depends on the OVER SCAN (above) setting. It is
not possible to adjust when the OVER SCAN is set to 0.
Description
IMAGE Menu
9