Connecting Speakers - Aiwa AV-NW50 Operating Instructions Manual

1, 2 and 3 in the illustration correspond to the following details.
1Sub woofer
1Surround speakers
Right Left

CONNECTING SPEAKERS 1

Speaker terminals
There are three types of speaker output terminals.
Screw type (FRONT SPEAKERS A)
The speaker terminal is opened by turning it counterclockwise.
After inserting the stripped wire into the terminal slot, tighten
down by turning it clockwise to secure the wire.
Flap type (FRONT SPEAKERS B, SURROUND SPEAKERS
and CENTER SPEAKER)
The speaker terminal is opened by lifting the terminal flap. After
inserting the stripped wire into the terminal slot, close the flap to
lock the wire in place.
Jack type (SUB WOOFER)
Simply plug in the sub woofer cord here.
B E R
S U
O F
W O
T
O U
6
ENGLISH
3AM antenna
3FM antenna
1Centre speaker
Connect front speakers (system A and/or B), a centre speaker,
surround speakers and a sub woofer to the corresponding
speaker terminals on the unit:
- the front speaker cords to the FRONT SPEAKERS terminals
When connecting only one set of front speakers, connect
them to the FRONT SPEAKERS A terminals.
The FRONT SPEAKERS B terminals (speaker system B) are
for use of 2 channel stereo system only.
- the centre speaker cord to the CENTER SPEAKER terminals
- the surround speaker cords to the SURROUND SPEAKERS
terminals
- the sub woofer (with a built-in amplifier) cord to the SUB
WOOFER jack, for more powerful bass sounds
- When not connecting the sub woofer, be sure to select
"
- When not connecting the centre speaker and/or surround
speakers, and regarding to the size of speakers (including
front speakers), speaker settings must be done. Before using
the unit, be sure to make speaker settings in accordance with
your speaker configuration (see page 16).
Speaker impedance
For all speakers, use speakers of 8 ohms or more.
Connecting + to +, - to - terminals
To get the proper sound effect, the speaker terminals on the unit
and the speaker should be connected with proper polarity; the
+ terminal on the unit should be connected to the + terminal on
the speaker (and - to -).
NOTE
• Be sure to connect the speaker cords correctly. Improper
connections can cause short circuits in the SPEAKER(S)
terminals.
• Do not leave objects generating magnetism near the speakers.
1Front speakers B
Right
2AC outlets
1Front speakers A
Right
" (sub woofer off) mode (see the next page).
Left
Left