Enable Sata Raid Option In Bios - HP xw9400 Service And Technical Reference Manual

Enable SATA RAID option in BIOS

To enable the SATA RAID option in BIOS:
1. During boot up, press
at the bottom of the screen.
2. If first boot, select the desired language and press Enter.
3. Use the arrow keys to highlight I/O>Device Options and press Enter.
4. Use the up/down arrow keys to place the cursor next to SATA RAID. Use the left/right arrow keys
to change the State to Enable.
NOTE
is a non-RAID SATA drive, this port should have RAID disabled.
5. Use the up/down arrow keys to place the cursor next to the ports that are not to be included in the
RAID array. Use the left/right arrow keys to change the state of each of them to Disable.
6. Press F10
7. Use the arrow keys to highlight File>Save Changes and Exit. Press Enter, then press
changes.
The workstation will reboot after the changes are saved. After the workstation reboots, the BIOS displays
the MediaShield copyright message.
146 Appendix B SATA devices
F10 to enter the Setup menu. Entering BIOS Setup (Press F10) appears
All six ports (0–5) then indicate they are enabled. If the operating system boot drive
when all ports have been set to the desired state.
F10 to save
ENWW