Getting Started; Basic Connections - GoVideo DVR5000 User Manual

Govideo dvr5000: product manual
Hide thumbs Also See for DVR5000:
Table of Contents

Advertisement

Basic Connections

In this chapter, you will
connect the DVD-VCR to
your television and run Auto
Setup, which automatically
searches for channels and sets
the player's internal clock.
NOTES:
• Advanced Connections are
covered in Appendix A.
• Even if you plan to use the
S-Video or Compo-
nent Video Outputs
you MUST connect
the DVD-VCR to
your television with either
the standard RF or the Line
Out connection. This
enables you to operate the
DVD-VCR setup menus.
1
Connect Antenna/Cable to DVD-VCR
Connect the RF antenna cable from your indoor/outdoor
antenna or cable wall outlet to the IN (FROM ANT.) jack
on the back panel of the DVD-VCR.
2
Connect DVD-VCR to TV
Choose one of the following methods to connect the
DVD-VCR to your TV:
RF Connection
Connect the supplied RF antenna cable from the OUT
(TO TV) jack on the back panel of the DVD-VCR to your
television's Antenna Input.
OR
Line Connection
Connect an RCA-type audio/video cable (red, white,
yellow) from the Line Out jacks on the back panel of the
DVD–VCR to your television's Line In jacks. Use red for
right audio, white for left audio, and yellow for video.
NOTE: It is recommended that you use the Line Con-
nection if your TV is equipped with RCA jacks.
3
Set DVD-VCR Output Channel
If you used the RF connection in Step 2, set the Channel
switch on the back panel of the DVD-VCR to 3 or 4,
whichever is not an active channel in your area.

2 - Getting Started

From Antenna
or Cable
To TV's
Antenna
Input
To TV's Line
Input
2 - GETTING STARTED
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents